Steris (AMSCO) Reliance 444 Washer

$29,700.00

The Reliance 444 Single-Chamber Washer/Disinfector, a mechanical washer/disinfector, is equipped with an Eagle® 3000 Stage 3TM control system. The washer/disinfector is designed with seven factory set cycles: Instruments, Gentle, Utensils, Glassware, Plastic Goods, Anesthesia/Respiratory Goods, and Decontamination. Three additional cycles are available for customized programming to meet specific operating requirements. Each pre-programmed cycle is equipped with Pre-Wash, Wash, Rinse, and Thermal Rinse (including Drain Discharge Cool Down) phases. The washer/disinfector is built to seismic design and includes a vented system and interior chamber light and offers both manifold and non-manifold washing and a power vertical sliding door, in a single- or double-door configuration.

Description

Dimensions

  • Exterior dimensions: 80″H x 42″W x 32.625”D (2032 x 1067 x 829 mm)
  • Interior chamber dimensions: 26″H x 24″W x 24”D (660 x 610 x 610 mm)
  • Load Height: 31” (787 mm) above finished floor

General

  • Vertical sliding power door(s) is constructed of tinted, tempered glass with stainless-steel trim to allow the operator to
  • view the chamber with the door closed. While a cycle is in progress, glass door remains cool to the touch.
  • Sliding door(s) is configured for power door operation.
  • Door is opened and closed automatically using touch pads on the control panel, located on the same side of the washer/disinfector as the door being operated.
  • Each power door includes a safety sensor to retract the door if an obstruction is detected in the doorway. If a power failure occurs, door(s) can be opened manually.
  • The manual access handle is located on the top edge of the door and concealed behind the top service panel. If double power doors are ordered, a door interlock feature is provided to help prevent cross-contamination.
  • Stainless-steel pump is powered by a dual-speed motor.
  • High pump speed provides the equivalent capacity of a 7.5 HP (5.6 kW) motor, 240 U.S. gal/min at 70 ft (910 L/min at 21.3 m) head pressure. Low pump speed provides the equivalent capacity of a 2 HP (1.4 kW) motor, 90 U.S. gal/min at 25 ft (341 L/min at 7.62 m) head pressure. Pump impeller is mounted directly on this motor shaft and does not require additional bearings.

Reviews

There are no reviews yet.

Be the first to review “Steris (AMSCO) Reliance 444 Washer”

Your email address will not be published.